Flashing Red Light in Electronics Box

Flashing Red Light in Electronics Box

Confirmed Issue:
There is a flashing red light on a part inside of the electronics box.

Affected Units:
Any Vandoit van

Issue Explanation:
The CL-305-103 device has a flashing red light that indicates the device is performing normally.  



Resolution: 
None needed.  The flashing red light is an indicator of good performance and is not a problem.  This device is what connects the rocker switches to the devices they power.  If you are seeing a different flashing red light, please contact Customer Support with a photo and a description by submitting a ticket through the Customer Support portal or emailing support@vandoit.com.

    • Related Articles

    • Troubleshooting a MaxxAir Fan Green Light

      Confirmed Issue: The MaxxAir Fan has a blinking green light and will not operate correctly. Affected Units: Any Vandoit with a MaxxAir Fan installed Issue Explanation: The green light on the MaxxAir Fan can occur for a couple reasons including ...

    • The Carbon Monoxide/Propane Monitor Is Going Off

      Confirmed Issue: The Carbon Monoxide monitor alarm is going off and shows a flashing red light. Affected Unit: Any Vandoit van Summary:  The CO monitor is very sensitive--four times more sensitive than a household CO monitor; the alarm will go off ...

    • Troubleshooting a Dead Ford Van Battery

      Confirmed Issue: The Ford van battery is dead and the vehicle will not start. Affected Units: Any Ford Transit with a Vandoit upfit. Summary: The Ford van battery is dead and the vehicle will not start. The van engine is not able to run, but the ...

    • Rocker Switches Are Not Working

      Confirmed Issue: The rocker switches are flickering or are no longer lighting up at all. Affected Units: Any Vandoit van Issue Explanation: The wiring for a resistor behind the front rocker switches may not be woven as tightly as needed. The wiring ...

    • Combimaster Overload Error

      Confirmed Issue: On the front of the Combimaster Inverter, the light under "inverter" is blinking red. The Mastervolt EasyView 5 Monitor is displaying an overload error in the Combimaster Inverter Device State widget. The inverter is not working ...